… building the framework for the woodshed, and the two sides are assembled. It doesn’t half look serious too, as indeed it should – 2 metres high and 1.5 metres deep and it will be 4 metres wide when it’s properly assembled.
Next stage of course is to dig the holes in order to plant the legs of the sides, but I’m not sure that I’ll be doing that tomorrow. Right now, it’s -7°C outside and dropping rapidly, and with one of the clearest starry skies that I have seen for a while, there’s no limit as to how low it might go.
Mind you, we had a gorgeous day today as well. Hardly a cloud in the sky all day and 78 amp-hours in the electric water-heater. It was quite enjoyable working outside.
And I’ll tell you something else. If you remember back to September, I bought a Ryobi Plus One Impact bit driver, and I used it today. It gets through the batteries but it drove the 6×60 screws right into the wood without very much effort at all, without any pilot holes – and we are talking real wood too, not this resinous pine stuff. I was well-impressed with that.
I finished that about 15 minutes before it went dark so I had a wood-cutting session – some of the rotten beams that I’d pulled out. And then I had to go to Marianne’s – she’s upgraded her computer but half of the programs that she has wouldn’t install. Hardly surprising, as some were for W98, but others just needed a little tweak. And back home, I had Rosemary on the phone for 15 minutes.
Now I have the fire banked up and I’m going nowhere.
