Once all of those were out of the way I carried on with the power board. This involved making up a flying lead so that I can connect all kinds of things to it – including the portable power board, if ever the need arises.<\/p>\n
Once I had done that, I had to make some cables to connect the dump load. This le to a good half an hour looking for the negative 25mm cable. <\/p>\n
And hereby hangs a tale. This cable only comes in blue and red, and I use only red and black for the 12-volt circuits. So you can see an immediate problem. However, I have learnt, by serendipity, that the red cable, if left out in the sunlight, fades to a nice dull yellow. I therefore have a couple,of lengths hanging upoutside quietly fading, but it took me ages to find the length that had already changed colour.<\/p>\n
Eventually I found it, and so I could make up a red cable and a yellow cable for thr dump load. As you know, my sldering is rubbish but I have a crimping tool for fastening the big aliminium terminals that I use, and then I finish off with half a dozen turns with the vice.<\/p>\n
Cecile rang up too for a chat,and she was on the phone for a good hour. Terry rang up too for a chat. It is nice to be popular.<\/p>\n
After lunch, I made up a couple of cables for the big Studer inverter. But I’m not at all sure about this. I bought it years ago off eBay and it’s never been installed, although when I gave it a whirl a few years ago, I found that the capacitor was faulty and I had to send it away to be repaired.<\/p>\n
The cables were not much problem, but fitting the inverter certainly was. You have no idea how heavy it is, and it’s hel on by screws through bolt holes, rather that cutaways, so you need at least four hands. After much binding in the marsh, I fitted a shelf onto the power board in the barn and put the inverter on that so that it was in the correct place – and then I could screw it up.<\/p>\n
I remain unconvinced about its effectiveness and I might end up taking it off again.<\/p>\n
I spent the rest of the evening looking for the keyswich that I put on one side on Sunday. This is actually a keyswitched battery isolator and I need that in my circuit so that I can disconnect the batteries without disrupting the system. I had it in my hand on Monday and put it safe where I knew that it wouldn’t be lost.<\/p>\n
And I have another three somewhere too – and could I ‘eck as like find one of those either. But this is the story of my life, isn’t it? I spend more time looking for stuff than I do actually using it or fitting it. <\/p>\n
